How to adjust the headlight??

  • Click here to become an Official Member of BMW Club Malaysia Download Form

bmw7833

Club Guest
Joined
Oct 14, 2006
Messages
9,160
Points
48
My driver side low beam (may be high beam too, but too less use the high beam, so not sure the high beam also goes down or not) lost the correct alignment after i repair the aircond last time (coz need to taken out the headlight to changed the dyer filter)..Want to ask, does anyone here know how to adjust the knobs on the back of headlight to make my low beam look higher than now??
 
maybe one of the bracket PATAH aledi tats why the lite is low saje
 
But my bulb casing is tight there ler..Normally if patah, then the casing will goyang-goyang one..
 
AB ada the headlight adjuster equipment than can adjust the headlight to factory spec... every impressive! If u service your car at AB, its FOC.
 
But problem is since i bought my car from AB, then i never come back to AB again..hahahhh..
 
astroboy;267984 said:
AB ada the headlight adjuster equipment than can adjust the headlight to factory spec... every impressive! If u service your car at AB, its FOC.

any idea if AB can adjust non-original headlight too? mine is DEPO set, wanna adjust the beam pattern, but scare original beam pattern not nice.
 
Russie;268118 said:
any idea if AB can adjust non-original headlight too? mine is DEPO set, wanna adjust the beam pattern, but scare original beam pattern not nice.

i don't think beam pattern can't be adjusted. AB only can adjust beam direction
 
True... pattern is created by the reflector behind the bulb.. AB can only adjust where the beam should be aimed.

Its quite impossible to get it right without the help of a big wall or the AB equipment.
 
Errmm..yesterday try to adjust on own effort, but still can not solve the problem, will go to AB later..Call them b4, their charge RM55. But now seems that not the headlight problem, may be caused by the level sensor underneath the engine bay..
 
hi guys,

i do agree with u guys that beam pattern cannot be changed. my concern is the blind spot, i have seen some cars with projector headlamps like the waja having blind/ gray spots, whereby the beam is only focused on certain area.
hmmm.... i wonder
 
Beam pattern is not adjustable as it is the property of the lens and projectors but if you want to adjust the directional pattern then there are actually 3 sections where you can fiddle with [using a slot and a phillips screwdriver] to get the perfect spotlighted sector.
You pm me your HP no and I will lead you thru the procedure, it's too lengthy to type out here as I am a one-finger typist, sorry.
 
Top Bottom