engine temperature for m43 318i

[subraputra]

Hi sifu,My car temperature needle always in 11 clock position and the temperatureReading in obc is max 105c.it is normal, just went to gua musang drive non stop8 hours but no over heating and the needle stay at same position allThe way.it is ok or my needle spoil but went do obc test the needleWorking perfectly.

 

[ICEMAN 68]

pretty fine and temp seems to be stable based on your description ....

are you waiting for the needle to be at 5 o'clock ?

 

[subraputra]

No lah bro some say the needle in the middle that y want to confirm
First

- - - Updated - - -

No lah bro some say the needle in the middle that y want to confirm
First

 

[ICEMAN 68]

No lah bro some say the needle in the middle that y want to confirm
First

- - - Updated - - -

No lah bro some say the needle in the middle that y want to confirm
First

that's just a say ...mine goes below the 11 o'clock mark during rainy days and goes sharp 12 on an adrenalin drive ....

Most importanly is do check your water level every week and also make sure your cooling components are up to date ... if you jsut got ya car ...the best is to replace the entire cooling system 1st ...new rad , hoses , thermostat , water pump etc etc ...

 

[subraputra]

All cooling system item is new bro.anyway thanks for the reply

 

[eujinee]

Hi sifu,
My car temperature needle always in 11 clock position and the temperature
Reading in obc is max 105c.it is normal, just went to gua musang drive non stop
8 hours but no over heating and the needle stay at same position all
The way.it is ok or my needle spoil but went do obc test the needle
Working perfectly.

my is always 12'o clock all the time..my is m43 too....so is normal..above 12 thn u might have some blockage, leaking,etc etc...

- - - Updated - - -

Hi sifu,
My car temperature needle always in 11 clock position and the temperature
Reading in obc is max 105c.it is normal, just went to gua musang drive non stop
8 hours but no over heating and the needle stay at same position all
The way.it is ok or my needle spoil but went do obc test the needle
Working perfectly.

my is always 12'o clock all the time..my is m43 too....so is normal..above 12 thn u might have some blockage, leaking,etc etc...

 

[subraputra]

Bro ieujinee, I found the problem ready it is meter out of calibration
After change new meter is now at 12 position.

- - - Updated - - -

Bro ieujinee, I found the problem ready it is meter out of calibration
After change new meter is now at 12 position.

 

[subraputra]

Bro ieujinee, I found the problem ready it is meter out of calibration
After change new meter is now at 12 position.

 

[eujinee]

great......

 

[Duke Of Red]

mine is always at the middle / 12 o'clock...meaning that it is good...right...thanks all...