Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
BMW Tech and Performance
General Tech
Trans failsafe prog & tyre puncture
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="hellgrace5" data-source="post: 27101" data-attributes="member: 14797"><p>Hi,I keep getting trans failsafe prog and did OBDII scan and got fault code as followEGS - 48FF - Ratio monitoring, gearshift 2-3 ( car will stay in 1st or 2nd gear only )PDC- 9E30 - Transducer, front right PDC - 9E36 -Transducer lines, rear centre rightalso the dash keep showing tyre puncture but none of the tyre is punctured.I tried scanning the tyre pressure control but couldn't get inside.I am using X431 Launch.Leave some advise, thanks!</p></blockquote><p></p>
[QUOTE="hellgrace5, post: 27101, member: 14797"] Hi,I keep getting trans failsafe prog and did OBDII scan and got fault code as followEGS - 48FF - Ratio monitoring, gearshift 2-3 ( car will stay in 1st or 2nd gear only )PDC- 9E30 - Transducer, front right PDC - 9E36 -Transducer lines, rear centre rightalso the dash keep showing tyre puncture but none of the tyre is punctured.I tried scanning the tyre pressure control but couldn't get inside.I am using X431 Launch.Leave some advise, thanks! [/QUOTE]
Verification
Post reply
Home
Forums
BMW Tech and Performance
General Tech
Trans failsafe prog & tyre puncture
Top
Bottom
