Menu
Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Reply to thread
Click here to become an Official Member of BMW Club Malaysia
Download Form
Home
Forums
The BMW Range
3 Series
E90, E91, E92, E93
E90 backlight to current E90 LCI
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="kimi yap" data-source="post: 556911" data-attributes="member: 22271"><p>Beside the boot lid & light:</p><p></p><p>1) You may need Wiring Harness for the both center light (reverse light), because there is some differences between pre-LCI and LCI. With harness, you could plug and play. Without the harness, in fact you still can manually switch the cable according to LCI configuration.</p><p></p><p>2) FRM module (located at passenger side) might need to be replaced if you are on V1. If V3, no need to replace at all. But most of the pre-LCI was installed with V2, just need some coding will do. Without replacing or coding on FRM module, your LED light will not work properly, bulb warning message pops up as well. </p><p>There is a workaround if you dont wish to do anything on the FRM, use a Resistor 8 - 10ohm with >50W (or your existing bulb), connect parallel with the LED light, all your error will gone, but this workaround is not recommended lar...</p></blockquote><p></p>
[QUOTE="kimi yap, post: 556911, member: 22271"] Beside the boot lid & light: 1) You may need Wiring Harness for the both center light (reverse light), because there is some differences between pre-LCI and LCI. With harness, you could plug and play. Without the harness, in fact you still can manually switch the cable according to LCI configuration. 2) FRM module (located at passenger side) might need to be replaced if you are on V1. If V3, no need to replace at all. But most of the pre-LCI was installed with V2, just need some coding will do. Without replacing or coding on FRM module, your LED light will not work properly, bulb warning message pops up as well. There is a workaround if you dont wish to do anything on the FRM, use a Resistor 8 - 10ohm with >50W (or your existing bulb), connect parallel with the LED light, all your error will gone, but this workaround is not recommended lar... [/QUOTE]
Verification
Post reply
Home
Forums
The BMW Range
3 Series
E90, E91, E92, E93
E90 backlight to current E90 LCI
Top
Bottom
